Installation manual

3-148
SIGNAMAX LLC • www.signamax.eu
Web – Click Port, Rate Limit, Input/Output Port/Trunk Configuration. Set the Input Rate
Limit Status or Output Rate Limit Status, then set the rate limit for the individual interfaces,
and click Apply.
Figure 3-87 Input Rate Limit Port Configuration
CLI - This example sets the rate limit level for input traffic passing through port 3.
Showing Port Statistics
You can display standard statistics on network traffic from the Interfaces Group and
Ethernet-like MIBs, as well as a detailed breakdown of traffic based on the RMON MIB.
Interfaces and Ethernet-like statistics display errors on the traffic passing through each
port. This information can be used to identify potential problems with the switch (such as
a faulty port or unusually heavy loading). RMON statistics provide access to a broad
range of statistics, including a total count of different frame types and sizes passing
through each port. All values displayed have been accumulated since the last system
reboot, and are shown as counts per second. Statistics are refreshed every 60 seconds
by default.
Note:
RMON groups 2, 3 and 9 can only be accessed using SNMP management software
such as HP OpenView.
Console(config)#interface ethernet 1/3 4-186
Console(config-if)#rate-limit input 500 4-211
Console(config-if)#