Installation manual

3-145
SIGNAMAX LLC • www.signamax.eu
Web – Click Port, Port/Trunk Broadcast Control. Set the threshold and mark the Enabled
field for the required interface, then click Apply.
Figure 3-85 Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 500 kilobits per
second for port 2.
9. Trunk Broadcast Control
Console(config)#interface ethernet 1/1 4-186
Console(config-if)#no switchport broadcast 4-193
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 500 4-193
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2 4-197
Information of Eth 1/2
Broadcast Threshold: Enabled, 500 Kbits/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, 100000 Kbits per second
Egress Rate Limit: Disabled, 100000 Kbits per second
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
Console#