Installation manual

3-144
SIGNAMAX LLC • www.signamax.eu
CLI – The following example displays the LACP configuration settings and operational
state for the remote side of port channel 1.
Setting Broadcast Storm Thresholds
Broadcast storms may occur when a device on your network is malfunctioning, or if
application programs are not well designed or properly configured. If there is too much
broadcast traffic on your network, performance can be severely degraded or everything
can come to complete halt.
You can protect your network from broadcast storms by setting a threshold for broadcast
traffic for each port. Any broadcast packets exceeding the specified threshold will then be
dropped.
Command Usage
• Broadcast Storm Control is enabled by default.
• Broadcast control does not effect IP multicast traffic.
Note:
Multicast and unknown unicast storm thresholds can also be set using the CLI (see the
“switchport broadcast packet-rate” command on page 4-193).
Command Attributes
• Port
8
- Port number.
•Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or 1000BASE-SFP)
• Protect Status – Enables or disables broadcast storm control. (Default: Enabled)
• Threshold – Threshold as percentage of port bandwidth. (Range: 64-100000 kilobits
per second for Fast Ethernet ports; 64-1000000 kilobits per second for Gigabit ports;
Default: 64 kilobits per second)
• Trunk
9
– Shows if a port is a trunk member.
Console#show lacp 1 neighbors 4-206
Port channel 1 neighbors
-------------------------------------------------------------------------
Eth 1/1
-------------------------------------------------------------------------
Partner Admin System ID: 32768, 00-00-00-00-00-00
Partner Oper System ID: 3, 00-12-CF-CE-2A-20
Partner Admin Port Number: 5
Partner Oper Port Number: 3
Port Admin Priority: 32768
Port Oper Priority: 128
Admin Key: 0
Oper Key: 120
Admin State: defaulted, distributing, collecting,
synchronization, long timeout,
Oper State: distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
.
.
.
8. Port Broadcast Control