Installation manual

3-137
SIGNAMAX LLC • www.signamax.eu
Command Attributes
Set Port Actor – This menu sets the local side of an aggregate link; i.e., the ports on this
switch.
• Port – Port number. (Range: 1-28)
• System Priority – LACP system priority is used to determine link aggregation group
(LAG) membership, and to identify this device to other switches during LAG
negotiations. (Range: 0-65535; Default: 32768)
- Ports must be configured with the same system priority to join the same LAG.
- System priority is combined with the switch’s MAC address to form the LAG identifier.
This identifier is used to indicate a specific LAG during LACP negotiations with other
systems.
• Admin Key – The LACP administration key must be set to the same value for ports that
belong to the same LAG. (Range: 0-65535; Default: 1)
• Port Priority – If a link goes down, LACP port priority is used to select a backup link.
(Range: 0-65535; Default: 32768)
Set Port Partner – This menu sets the remote side of an aggregate link; i.e., the ports on
the attached device. The command attributes have the same meaning as those used for
the port actor. However, configuring LACP settings for the partner only applies to its
administrative state, not its operational state, and will only take effect the next time an
aggregate link is established with the partner.