Installation manual

3-135
SIGNAMAX LLC • www.signamax.eu
Enabling LACP on Selected Ports
Command Usage
• To avoid creating a loop in the network, be sure you
enable LACP before connecting the ports, and also
disconnect the ports before disabling LACP.
• If the target switch has also enabled LACP on the
connected ports, the trunk will be activated
automatically.
• A trunk formed with another switch using LACP will
automatically be assigned the next available trunk ID.
• If more than eight ports attached to the same target
switch have LACP enabled, the additional ports will be
placed in standby mode, and will only be enabled if one
of the active links fails.
• All ports on both ends of an LACP trunk must be configured for full duplex, and
auto-negotiation.
• Trunks dynamically established through LACP will also be shown in the Member List on
the Trunk Membership menu (see page 3-134).
Command Attributes
• Member List (Current) – Shows configured trunks (Port).
• New – Includes entry fields for creating new trunks.
- Port – Port identifier. (Range: 1-28)
Web – Click Port, LACP, Configuration. Select any of the switch ports from the
scroll-down port list and click Add. After you have completed adding ports to the member
list, click Apply.
Figure 3-80 LACP Trunk Configuration
active
links
}
}
dynamically
enabled
configured
members
backup
link