Installation manual

3-114
SIGNAMAX LLC • www.signamax.eu
Web – Specify the action (i.e., Permit or Deny). Specify the source and/or destination
addresses. Select the address type (Any, Host, or MAC). If you select “Host,” enter a
specific address (e.g., 11-22-33-44-55-66). If you select “MAC,” enter a base address and
a hexadecimal bitmask for an address range. Set any other required criteria, such as VID,
Ethernet type, or packet format. Then click Add.
Figure 3-67 Configuring MAC ACLs
CLI – This example configures one permit rule for all source mac addresses to
communicate with all destination mac addresses on VLAN 12, and another permit rule for
source mac address to communicate with all destination mac addresses.
Console(config-mac-acl)#permit any any vid 12 4095 4-182
Console(config-mac-acl)#permit host 00-10-b5-e9-52-79 any
Console(config-mac-acl)#