Installation manual

3-96
SIGNAMAX LLC • www.signamax.eu
• IP address can be configured for SNMP, web and Telnet access respectively. Each of
these groups can include up to five different sets of addresses, either individual
addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the switch will
not accept overlapping address ranges. When entering addresses for different groups,
the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete the
entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by specifying
both the start address and end address.
Command Attributes
• Web IP Filter – Configures IP address(es) for the web group.
• SNMP IP Filter – Configures IP address(es) for the SNMP group.
• Telnet IP Filter – Configures IP address(es) for the Telnet group.
• IP Filter List – IP address which are allowed management access to this interface.
• Start IP Address – A single IP address, or the starting address of a range.
• End IP Address – The end address of a range.
• Add/Remove Filtering Entry – Adds/removes an IP address from the list.
Web – Click Security, IP Filter. Enter the IP addresses or range of addresses that are
allowed management access to an interface, and click Add Web IP Filtering Entry to
update the filter list.
Figure 3-55 Creating an IP Filter List