System information

SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
42
Copytocpu: Specify “copytocpu” to send a
copy of packets to CPU.
redir-port <1-26>
or redir-port <1-28>
Configure which port is the redirect port.
<1-26>: Specify a port number between 1 and
26. When action is set to “redirect”, packets will
be sent to the designated redirect port.
logging <1-128>
Specify a logging ID that applies to this ACL
rule.
rate-lim <1-128>
Specify the rate limiting ID that applies to this
ACL rule.
newsvid <1-4094>
Specify a new service provider VID.
<1-4094>: Specify a new service provider VID.
repcvid <enable | disable>
Specify to replace the customer VID or not.
<enable | disable>: Specify “enable” to replace
with a new customer VID. Specify “disable” to
not replace with a new customer VID.
newcvid <1-4094>
Specify a customer VID to replace old one in
egress traffic.
<1-4094>: Specify a new customer VID.
reass-queue <enable | disable>
Replace the customer priority or not.
<enable | disable>: Specify “enable” to replace
with a new priority. Specify “disable” to not
replace with a new priority.
new-queue <0-7>
Specify a customer priority queue to replace an
old one for egress traffic.
<0-7>: Specify a new priority queue between 0
and 7. The priority queue setting can be
changed by issuing remarking command.
Please refer to Remarking command mode
section for detailed descriptions.
exit
Quite the current mode and return to ACL
Configuration mode.
show
Show or verify the ACL rule that you configure.
2.6.2 Dot.1X command mode
Enter the dot1x command in Configuration mode. Then, the dot1x mode shows as follows:
SWH(config)# dot1x
SWH(config-dot1x)#
Command Purpose & Description Usage
=================== =========================== =============================
sys Enter Sys Cmd. Mode sys
state Set State state <port_list> <type>
authentic Reset Authenticate authentic <port_list>
exit Exit from current mode exit
show Show Dot1x Settings show
SWH(config-dot1x)#