System information

SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
30
is completely forbidden.
NOTE 1: When the community browses the
Managed Switch without proper access right,
the Managed Switch will respond nothing. For
example, if a community only has Read & Write
privilege, then it cannot browse the Managed
Switch’s user table.
NOTE 2: If you would like to edit the settings of
your new account, you can enter the command
community community name under the
SWH(service-snmp)#.
For example:
If you want to edit settings of the account
“admin”, you can use the following commands to
enter the editing mode.
SWH# service
SWH(service)# snmp
SWH(service-snmp)# community admin
SWH(snmp-community_admin)#
exit
Quit the Community mode and return to SNMP
service mode.
show
Show detailed information of this community.
add <trap_id> <trap_ip>
<community>
To add a new trap destination. This function will
send traps to the specified destination.
<trap_id>: 1~10
<trap_ip>: The specific IP address of the
network management system that will receive
the trap.
<community>: Enter the community name of
up to 20 characters.
For example:
SWH(snmp-trap-dest)# add 1 192.168.1.113
trapcommu1
NOTE: If you would like to edit the settings of a
trap destination, you can enter the command
trap-dest trap id under the SWH(service-
snmp)#.
For example:
If you want to edit settings of the trap destination
“2”, you can use the following commands to
enter the editing mode.
SWH# service
SWH(service)# snmp
SWH(service-snmp)# trap-dest 2
SWH(snmp-trap-dest_2)#
delete <trap_id>
To delete a registered trap destination.
SWH(snmp-trap-dest)# delete 1
SWH(snmp-trap-
dest)#
exit
Quit the Trap Destination mode and return to
SNMP service mode.