User`s guide

Signamax 065 -1163 F series RS-232/422/485 to 100BaseFX Media Converter

Configuration

Command Definitions

backup: Use this command to save configuration settings

to file.

exit: Type exit or logout and press ENTER to quit the

program.

help: To access help commands list.

ping: Type ping followed by a space, and then the IP

address of the device to send a test signal. If a

response is received, then the device is connected.

To view a full list of ping options, type ping and press

ENTER.

reset: Type reset config and press ENTER to load

factory default settings, or type reset system and

press ENTER to restart the system.

show: Type show to display a full list of view commands.

set: To configure the management console, type the

commands below, followed by the ENTER key.

NOTE: Separate each port of the command line with a space.

set admin - follow the prompts to change user

name and password

set cfg – the command is for factory setting

use

set eth0 ip (new IP address) network mask

(new network mask) gateway

(new gateway). Use this command

to set new addresses.

set idle (time in seconds) – set automatic

logout when the program or