User`s guide

Signamax 065 -1163 F series RS-232/422/485 to 100BaseFX Media Converter
Configuration
21
with other devices with the same defaults.
NOTE: Prior to following the instructions listed below for
Remote Computer Login, ensure that a serial cable
connection between the media converter and remote
workstation exists.
Remote Computer Login
1. The default Login name is “admin” with no preset
password. After successful login, type the following
command line to change the device IP address in CLI
mode where xxx’s represent values between 0 and 254
and the user should enter their own IP address in this
form.
• telnet xxx.xxx.xxx.xxx.
2. After entering the new IP address, the system will
confirm that the operation is successful.
NOTE: Copy the new address down on a piece of paper. You
will need the address when you are going to use
Telnet or set up a data transfer/communication
connection.
WARNING: IP addresses are unique! If an address
isn’t available, please contact the
appropriate authorities to apply for one.
3. After you log into the system, you will see a welcome
message on-screen.