User`s guide

Signamax 065 -1163 F series RS-232/422/485 to 100BaseFX Media Converter
Configuration
15
password. After successful login, type the following
command line to change the device IP address in CLI
mode where xxx’s represent values between 0 and 254,
and the user should enter their own IP address in this
form.
• set eth0 ip xxx.xxx.xxx.xxx
2. After entering the new IP address. The system will
confirm whether the operation is successful.
NOTE: Copy the new address down on a piece of paper. You
will need the address when you are going to use
Telnet or set up data transfer/communication
connection.
WARNING:
IP addresses are unique! If an address isn’t available,
please contact the appropriate authorities to apply for
one.
3. After you log into the system, you will see a welcome
message on-screen.
4. Press ENTER and on the following screen, type the
default username admin, leave the password field blank
since there is no default value and press ENTER to