User`s guide

Signamax

™

10/100TX to 100FX Media Converter

6 User’s Manual

One-Channel Media Converter

Ports

The Converter provides one TX port and one FX port. For the

FX port, it provides options of multi-mode fiber using SC, ST,

VF-45, MT-RJ or LC connector, single-mode fiber using SC

connector, and WDM single-fiber (bi-direction) transceiver

using SC connector. For the TX port, it uses RJ-45 connector

and auto senses the speed of 10/100Mbps.

Port Settings

Port settings are made very simple by means of a DIP (Dual

Inline Package) switch at the rear panel of the module.

1 2 3 4 5 6

DIP switch

There are six pins on the DIP switch for port settings. Refer

to the table below for more details.

DIP

switch

No.

Down (Default Setting) Up

1 Enable LFPT Disable LFPT LFPT:

link-fault-

pass-

through

2 Enable auto negotiation for

TX port

Enable f orced mode f or

TX port

3 TX por t for ced to

100Mbps

TX port forced to 10Mbps

4 TX port forced to full

duplex mode

TX por t for ced to half

duplex mode

5 FX port forced to full

duplex mode

FX port forced to half

duplex mode