User`s guide

Signamax ™ 10/100TX to 100FX Media Converter
User’s Manual 7
 First, disconnect the converter from the power. Then toggle Pin 2 of the
DIP switch to the up position to enable the forced mode for TX port.
<NOTE> Pin 2 must be toggled up prior to speed and du
plex mode settings
manually.
 Toggle down Pin 3 to force the TX port at the speed of 100Mbps. Or toggle
up Pin 3 for 10Mbps speed.
 Toggle do
wn Pin 4 to force the TX port at full duplex mode. Or toggle up
Pin 4 for half duplex mode.
 Toggle do
wn Pin 5 to force the FX port at full duplex mode. Or toggle up
Pin 5 for half duplex mode.
 Toggle dow
n Pin 1 to disable the link-fault-pass-through.
 Connect the con
verter to the power again. The new setting will come into
effect then.
Front Panel & LEDs
LED Indicators
The LED indicators give you instant feedback on status of the
converter:
LEDs State Indication
Steady Power on
PWR stands for POWER
PWR
Off Power off
Steady Connection at the speed of 100Mbps 100 (Mbps)
Off Connection at the speed of 10Mbps
Steady A valid network connection established
LNK stands for LINK
Flashing Transmitting or receiving data
ACT stands for ACTIVITY
LNK/ACT
Off Neither valid network connection established
nor transm
itting/receiving data.
Steady Connection in full duplex mode
FDX stands for FULL-DUPLEX
Flashing Collision occurred
COL stands for COLLISION
FDX/COL
Off Connection in half-duplex mode