Instruction manual

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, 627 00 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
1.4 Specifications
Copper Ports w/h PSE (P2-P5)
Compliance IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX
Connectors Shielded RJ-45 jacks
Pin assignments Auto MDI/MDI-X detection
Configuration Auto-negotiation
Transmission rate 10Mbps, 100Mbps
Duplex support Full/Half duplex
Network cable Cat.5 UTP
Power over Ethernet IEEE 802.3af-compliant PSE (function equipped in PoE Model only)
Combo Port (P1)
Compliance IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX/100Base-FX
Interface Selection Fiber is selected if an SFP fiber transceiver is installed in SFP slot
Copper Interface
Connector Shielded RJ-45 jack
Pin assignments Auto MDI/MDI-X detection
Configuration Auto-negotiation or software control
Transmission rate 10Mbps, 100Mbps
Duplex support Full/Half duplex
Network cable Cat.5 UTP
Fiber Interface
Connector SFP slot for optional SFP type fiber transceivers
Configuration 100Mbps, Full duplex
Far End Fault Support Enabled
Network cables MMF 50/125 60/125, SMF 9/125
Eye safety IEC 825 compliant
Switch Functions
MAC Addresses Table 1K entries
Forwarding & filtering Non-blocking, full wire speed
Switching technology Store and forward
Maximum packet length 1536 bytes
Flow control IEEE 802.3x pause frame base for full duplex operation