User manual

Signamax Connectivity System 065-9066
www.signamax-us.com www.signamax-eu.com
2. Change the IP address to 192.168.1.2(2~254 is ok)
3. Change the subnet mask to 255.255.255.0
4. Change the gateway and the preferred DNS server to 192.168.1.1
IP configu
IP configuIP configu
IP configuration
rationration
rations
ss
s above please refer to page 15
3. After
3. After3. After
3. After Network Configuration is done.
Network Configuration is done. Network Configuration is done.
Network Configuration is done.
Connecting to an External Ethernet Hub or Switch:
Connecting to an External Ethernet Hub or Switch: Connecting to an External Ethernet Hub or Switch:
Connecting to an External Ethernet Hub or Switch:
1 Connect the Ethernet cable (with RJ-45 connector) to WAN port.
2 Connect the other end of the Ethernet cable to DSL/Cable modem or the external Ethernet hub
or switch.
[Notice: If It's not able to access the GSM Gateway via Internet
Please follow step.2 to enter gateway, the values are special premade settings]
Port
PortPort
Port Description
DescriptionDescription
Description
Phone FXS port can be connected to analog telephone sets or
Trunk Line of PBX.
Line Line is used to connect to a PSTN line of carrier.
SIM After Inserting SIM card ,the gateway is able to work as
a mobile phone.
Antenna Connector Connect the antenna to the connector
WAN For Setting
For Setting For Setting
For Setting Connect directly to your PC with RJ 45
For WA
For WAFor WA
For WAN
NN
N Connect to the network with an Ethernet cable.
This port allows your GW to be connected to an Internet
Access device, e.g. router, cable modem, ADSL modem,
through a networking cable with RJ-45 connectors used
on 10BaseT and 100BaseTX networks.
RES Push this button until 3 seconds, and GW will be set to
factory default configuration.
AC power(DC in 12V) A power supply cable is inserted