Specifications

B
MEDIA
CONVERTER
SYSTEM
TM
www.signamax.eu
B26
• Supports standard 19" 3U high rack-mount chassis with 16 slots for converter modules
• 19-inch rack mount
- The concentrator unit will fit in both Electronic Industries Association (EIA) standard compliant racks.
• Supports 3 fans for chassis heat radiating
• Operating temp range 0° – 50°C
• Supports chassis temperature detection with F/C both degree
• Supports FAN rotation rate (RPM) detection
• Supports chassis ID (CID) for chassis location indication
• Built-in management CPU module:
- Supports DB-9 RS232 interface for console
- Supports two Ethernet ports in management network
• Management Board LED display: PowerA/B, UTP port: Act/Link, CPU Run
• Supports hot-swappable and upgradeable management CPU module
• Supports hot-swappable converter modules
• Supports hot-swappable and loading-shared redundant power units, each can be DC or AC. Independent power
input for each power modules
• Supports Real-Time Clock (RTC)
• Power monitor (absent/present, ON/OFF, DC/AC), fans monitor and temperature monitor
• Power supply: Hot-swap redundant, high reliability/safety
• Supports CO/CPE conversion port configuration for port state, Speed/Duplex, Flow Control and Bandwidth
setting
• Comply with RoHS Requirement
• Provides a Gigabit Ethernet PON (Passive Optical Network), converting 10/100/1000 Mbps Ethernet into optical
signals with an optical coupler for point-to-multipoint networks. The EPON OLT converter module for the center
unit can be selected to provide datacom service for distances of up to 20 km. The same subscriber unit EPON
ONU converter is used for remote CPE site, whether 20 km type.
• One OLT handles up to 32 subscribers per fiber
- Implements full duplex with single SM fiber links, along with an optical coupler for 32 branches, making it
possible to handle up to 32 subscribers per single optical fiber
• One chassis supports up to 512 subscribers
- The center unit (rear access type) uses high-density packing to fit up to 512 subscribers into a 3U case height
(132 mm), saving your valuable rack space
• Independent channel configuration
- Additional EPON converter module can be added as needed to economically handle subscriber growth.
In addition, maintenance is possible in channel units, making it possible to respond to a fault on one channel
without affecting the others.
KEY FEATURES