Specifications

B
MEDIA
CONVERTER
SYSTEM
TM
www.signamax.eu
B8
The Signamax VDSL Ethernet Externder is a point-to-point DSL solution that efficiently extends
10/100 Ethernet circuits to over 600 meters (1,960 feet) at 30 Mbps using existing straight pair copper wire.
The 065-1138 will allow Ethernet Networking in existing facilities without pulling extra cable. This is
the perfect solution to Ethernet on the factory floor where systems have been upgraded from slower
serial communications to Ethernet networkig.
Installation is easy with a single switch setting, one end is set for local and the other remote.
The 065-1138 is used in pairs to extend Ethernet connectivity over existing voice grade copper wire.
VDSL Ethernet Extender
PART NO. DESCRIPTION
065-1138 10/100BaseT/Tx Ethernet over VDSL Extender
VDSL Ethernet Extender
KEY FEATURES
• High-Speed Full-Duplex 30Mbps communications link over existing
copper cable, Symetric alon the VDSL
• 8 Speeds with speed indiator LEDs on top of unit 30 Mbps @ up to
1,970 ft., ratchets down to 1 Mbps @ about 6,200 ft.
• Operates transparent to high layer protocols such as TCP/IP
• Auto-MDIX and Auto-sensing 10Base-T or 100Base-TX and Full
or Half-Duplex on the Ethernet port
• Plug and Play design for simple installation, single switch config
• Eleven status LEDs for simple monitoring of the device and
connection status
SPECIFICATIONS
STANDARDS
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-TX
Ethernet over VDSL
PROTOCOL
Transparent to higher layer protocols
CONFIGURATION
One DIP switch set: Local (CO) or Remote (CPE)
A link is established between a Local unit and a Remote unit (plug & play)
ETHERNET INTERFACE
One RJ-45 connector Auto-MDIX and Auto-sensing 10/100Base-T/TX
and Full/Half-duplex
VDSL COPPER INTERFACEL
One RJ-11 connector VDSL port
TRANSMISSION
Ethernet Data Rate: 10/100Mbps Full/Half-Duplex
VDSL line rate: 1/3/5/10/15/20/25/30 Mbps
CABLE CONNECTION
RJ-45 (10BASE-T): UTP CAT. 3, 4, 5 (2-pair wire)
RJ-45 (100BASE-TX): UTP CAT. 5 (2-pair wire)
VDSL: Telephone line 24 AWG (0.5mm diameter, 1-pair wire) or larger
CABLE LENGTH
Ethernet: Maximum 100 meters (328 ft.) (UTP LAN cable)
VDSL: Maximum 1,900 meters (6,230 ft., 0.5 mm diameter phone line)
LEDS
Ethernet: Lnk/Act, Fdx
VDSL: Err, Lnk, Loc, Rmt
POWER
Power Input: 12V DC @ 0.8A, external power supply adapter
Frequency: 47Hz to 63Hz
PHYSICAL CHARACTERISTICS
Power Adapter: Universal 100-240 VAC
50-60 Hz 12VDC 0.2A External Power Supply
Power Dissipation: 2.4 W Max
Operating Temperature: 0 to 60°C
Storage Temperature: -20 to 70°C
Operating Humidity: 10-90%, non-condensing
Dimensions: 80.3 x 109.2 x 23.8 mm (W x D x H)
Weight: 150 g
EMISSIONS
FCC part 15 Class A, CE Mark