User`s manual

Signamax ™ 065-7840C-WS 24-Port 10/100/1000BaseT/TX WebSmart Switch
Publication date: June, 2011
Revision 1.0
101
5. Maintenance
5-1. Resolving No Link Condition
The possible causes for a no link LED status are as follows:
 The attached device is not powered on.
 The cable may not be the correct type or is faulty.
 The installed building premise cable is faulty.
 The port may be faulty.
5-2. Q&A
1. Computer A can connect to Computer B, but cannot connect to Computer C
through the 065-7940C-WS WebSmart Switch.
 The network device of Computer C may have failed to work. Please check
the link/act status of Computer C on the LED indicator. Try another network
device on this connection.
 The network configuration of Computer C may be set to something wrong.
Please verify the network configuration on Computer C.
2. The uplink connection function fails to work.
 The connection ports on another must be connection ports. Please check if
connection ports are used on that 065-7940C-WS WebSmart Switch.
 Please check the uplink setup of the 065-7940C-WS WebSmart Switch to
verify that the uplink function is enabled.
3. The console interface cannot appear on the console port connection.
 The 065-7940C-WS switch has no console port, so you cannot use a
console interface to connect with the switch.
4. How to configure the 065-7940C-WS WebSmart Switch.
 User can use the IE browser program in the Windows series of computers to
control the WebSmart functions in the 065-7940C-WS switch. First, choose
any port in the 065-7940C-WS switch. Then, use IE and type the default IP
address, 192.168.1.1, to connect to the switch with a RJ45 network cable.
The login screen will appear at once.