User`s guide

Signamax 065-7931 16-Port 10/100/1000BaseT/TX WebSmart Switch

4-2-9. Bandwidth Management

Function name:

Bandwidth Management

Function description:

Bandwidth Management function is used to set up the limit of Ingress and

Egress bandwidth for each port.

Note:

Each port of the switch is assigned a 16 KB packet buffer. The packet buffer

size will be reduced when the bandwidth rate limitation is enabled. This may

cause jumbo frames not to be forwarded.

Please avoid enabling the jumbo frame capability and bandwidth rating / rate

limiting functions at the same time.

Fig. 4-19

Parameter description:

Port Number:

Choose the port on which you would like this function to operate. Valid

range of the port is 1~16. The user is also permitted to choose “All” in

the selection list to simplify the procedure of configuring all ports at the

same time.

All Traffic for Ingress Rate Limiting:

Establishes the limit of Ingress bandwidth for the port selected. Incoming

traffic will be discarded if the rate exceeds the value established in the

Data Rate field. Pause frames are also generated if flow control is

enabled. The format of the packet limits to unicast, broadcast and

multicast. Valid range is 0~1000.