User`s guide

Signamax 065-7931 16-Port 10/100/1000BaseT/TX WebSmart Switch

2-1-3-1. Configuring Management Agent of the 065-7931 16-Port

10/100/1000BaseT/TX WebSmart Switch through an Ethernet Port

There are two ways to configure and monitor the switch through the switch’s

Ethernet port: by using a Web browser and by using an SNMP manager. The user

interface for the SNMP manager is NMS dependent and is not covered here; the

Web-based UI for the switch is a highly user-friendly interface.

• Managing the 065-7931 16-Port 10/100/1000BaseT/TX WebSmart Switch

through an Ethernet Port

Before the user communicates with the switch, they must first finish the

configuration of the IP address or know the current IP address of the switch. Then,

the user must follow the procedures listed below.

1. Set up a physical path between the configured the switch and a PC

by a qualified UTP Cat. 5 cable with RJ-45 connector.

Note: If PC directly connects to the switch, you have to setup the

same subnet mask between them. However, the subnet mask may

be different for the PC in the remote site. Please refer to Fig. 2-6

regarding the 065-7931 16-Port 10/100/1000BaseT/TX WebSmart

Switch default IP address information.

2. Run the web browser and follow the menu. Please refer to Chapter

065-7931 16-port 10/100/1000BaseT/TX WebSmart Switch

Default IP Setting:

IP = 192.168.1.1

Subnet Mask = 255.255.255.0

Default Gateway = 192.168.1.254

Assign a reasonable IP address,

For example:

IP = 192.168.1.100

Subnet Mask = 255.255.255.0

Default Gateway = 192.168.1.254

. 2-6

Ethernet LAN