User`s guide

Signamax 065-7931 16-Port 10/100/1000BaseT/TX WebSmart Switch
8
2. Installation
2-1. Starting Up the 065-7931 16-Port Gigabit WebSmart Switch
This section will give users a quick start for:
- Hardware and Cable Installation
- Management Station Installation
- Software booting and configuration
2-1-1. Hardware and Cable Installation
Before beginning the installation, please do the following:
⇒ Wear a grounding device to avoid the damage from electrostatic discharge
⇒ Be sure that the power switch is OFF before you insert the power cord to the
power source
• Installing Optional SFP Fiber Transceivers into the 065-7931 Gigabit
WebSmart Switch
Note: If you have no modules, please skip this section.
• Connecting the SFP Module to the Chassis:
The optional SFP modules are hot swappable, so you can plug or unplug it
before or after powering on.
1. Verify that the SFP module is the right model and conforms to the chassis
2. Slide the module along the slot. Also be sure that the module is properly
seated against the slot socket/connector
3. Install the media cable for network connection
4. Repeat the above steps, as needed, for each module to be installed into
the slot(s)
5. Turn the power ON after the above procedures are done, if the switch was
not powered on
Fi
g
. 2-1 Installation of O
p
tional SFP Fiber Transceive
r