User manual

User Manual

Publication date: Feb., 2013

Revision A3

z Action :

Specify the action to take with a frame that hits this ACE.

Permit: The frame that hits this ACE is granted permission for the ACE

operation.

Deny: The frame that hits this ACE is dropped.

z Rate Limiter :

Specify the rate limiter in number of base units. The allowed range is 1 to 16.

Disabled indicates that the rate limiter operation is disabled.

z Port Redirect :

Frames that hit the ACE are redirected to the port number specified here. The

allowed range is the same as the switch port number range. Disabled indicates

that the port redirect operation is disabled.

z Mirror :

Specify the mirror operation of this port. Frames matching the ACE are

mirrored to the destination mirror port. The allowed values are:

Enabled: Frames received on the port are mirrored.

Disabled: Frames received on the port are not mirrored.

The default value is "Disabled".

z Logging :

Indicates the logging operation of the ACE. Possible values are:

Enabled: Frames matching the ACE are stored in the System Log.

Disabled: Frames matching the ACE are not logged.

Please note that the System Log memory size and logging rate is limited.

z Shutdown :

Indicates the port shut down operation of the ACE. Possible values are:

Enabled: If a frame matches the ACE, the ingress port will be disabled.

Disabled: Port shut down is disabled for the ACE.

z Counter :

The counter indicates the number of times the ACE was hit by a frame.

z Buttons

Apply – Click to save changes.

Reset- Click to undo any changes made locally and revert to previously saved

values.

VLAN Parameter description:

z 802.1Q Tagged :

Specify whether frames can hit the action according to the 802.1Q tagged. The

allowed values are:

Any: Any value is allowed ("don't-care").

Enabled: Tagged frame only.

Disabled: Untagged frame only.

The default value is "Any".