User manual

User Manual
Publication date: Feb., 2013
Revision A3
264
A. Glossary of Web-based Management
A
ACE
ACE is an acronym for Access Control Entry. It describes access permission associated with
a particular ACE ID.
There are three ACE frame types (Ethernet Type, ARP, and IPv4) and two ACE actions
(permit and deny). The ACE also contains many detailed, different parameter options that are
available for individual application.
ACL
ACL is an acronym for Access Control List. It is the list table of ACEs, containing access
control entries that specify individual users or groups permitted or denied to specific traffic
objects, such as a process or a program.
Each accessible traffic object contains an identifier to its ACL. The privileges determine
whether there are specific traffic object access rights.
ACL implementations can be quite complex, for example, when the ACEs are prioritized for
the various situation. In networking, the ACL refers to a list of service ports or network
services that are available on a host or server, each with a list of hosts or servers permitted or
denied to use the service. ACL can generally be configured to control inbound traffic, and in
this context, they are similar to firewalls.
There are 3 web-pages associated with the manual ACL configuration:
ACL|Access Control List: The web page shows the ACEs in a prioritized way, highest (top) to
lowest (bottom). Default the table is empty. An ingress frame will only get a hit on one ACE
even though there are more matching ACEs. The first matching ACE will take action
(permit/deny) on that frame and a counter associated with that ACE is incremented. An ACE
can be associated with a Policy, 1 ingress port, or any ingress port (the whole switch). If an
ACE Policy is created then that Policy can be associated with a group of ports under the
"Ports" web-page. There are number of parameters that can be configured with an ACE. Read
the Web page help text to get further information for each of them. The maximum number of
ACEs is 64.
ACL|Ports: The ACL Ports configuration is used to assign a Policy ID to an ingress port. This
is useful to group ports to obey the same traffic rules. Traffic Policy is created under the
"Access Control List" - page. You can you also set up specific traffic properties (Action / Rate
Limiter / Port copy, etc) for each ingress port. They will though only apply if the frame gets
past the ACE matching without getting matched. In that case a counter associated with that
port is incremented. See the Web page help text for each specific port property.
ACL|Rate Limiters: Under this page you can configure the rate limiters. There can be 15
different rate limiters, each ranging from 1-1024K packets per seconds. Under "Ports" and
"Access Control List" web-pages you can assign a Rate Limiter ID to the ACE(s) or ingress
port(s).
AES
AES is an acronym for Advanced Encryption Standard. The encryption key protocol is applied
in 802.1i standard to improve WLAN security. It is an encryption standard by the U.S.
government, which will replace DES and 3DES. AES has a fixed block size of 128 bits and a
key size of 128, 192, or 256 bits.
APS
APS is an acronym for Automatic Protection Switching. This protocol is used to secure that
switching is done bidirectional in the two ends of a protection group, as defined in G.8031.
Aggregation