User manual

User Manual
Publication date: Feb., 2013
Revision A3
240
server is counted as a Request as
well as a timeout.
Other Info
This section contains information about the state of the server and the latest round-trip time.
Name RFC4670 Name Description
IP
Address
-
IP address and UDP port for the accounting server
in question.
State
-
Shows the state of the server. It takes one of the
following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP communication is
up and running, and the RADIUS module is ready to
accept accounting attempts.
Dead (X seconds left): Accounting attempts were
made to this server, but it did not reply within the
configured timeout. The server has temporarily been
disabled, but will get re-enabled when the dead-time
expires. The number of seconds left before this
occurs is displayed in parentheses. This state is only
reachable when more than one server is enabled.
Round-
Trip Time
radiusAccClientExtRoundTripTime
The time interval (measured in milliseconds)
between the most recent Response and the
Request that matched it from the RADIUS
accounting server. The granularity of this
measurement is 100 ms. A value of 0 ms indicates
that there hasn't been round-trip communication with
the server yet.
z Buttons:
Auto-refresh –Check this box to enable an automatic refresh of the page at
regular intervals.
Refresh - Click to refresh the page immediately.
Clear - Clears the counters for the selected server. The "Pending Requests"
counter will not be cleared by this operation.