User manual

User Manual
Publication date: Feb., 2013
Revision A3
238
Bad authenticators or Message
Authenticator attributes or unknown
types are not included as malformed
access responses.
Rx
Bad
Authenticato
rs
radiusAuthClientE
xtBadAuthenticat
ors
The number of RADIUS Access-
Response packets containing invalid
authenticators or Message Authenticator
attributes received from the server.
Rx
Unknown
Types
radiusAuthClientE
xtUnknownTypes
The number of RADIUS packets that
were received with unknown types from
the server on the authentication port and
dropped.
Rx
Packets
Dropped
radiusAuthClientE
xtPacketsDroppe
d
The number of RADIUS packets that
were received from the server on the
authentication port and dropped for
some other reason.
Tx
Access
Requests
radiusAuthClientE
xtAccessRequest
s
The number of RADIUS Access-
Request packets sent to the server. This
does not include retransmissions.
Tx
Access
Retransmissi
ons
radiusAuthClientE
xtAccessRetrans
missions
The number of RADIUS Access-Request
packets retransmitted to the RADIUS
authentication server.
Tx
Pending
Requests
radiusAuthClientE
xtPendingReques
ts
The number of RADIUS Access-
Request packets destined for the server
that have not yet timed out or received a
response. This variable is incremented
when an Access-Request is sent and
decremented due to receipt of an
Access-Accept, Access-Reject, Access-
Challenge, timeout, or retransmission.
Tx
Timeouts
radiusAuthClientE
xtTimeouts
The number of authentication timeouts
to the server. After a timeout, the client
may retry to the same server, send to a
different server, or give up. A retry to the
same server is counted as a retransmit
as well as a timeout. A send to a
different server is counted as a Request
as well as a timeout.
Other Info
This section contains information about the state of the server and the latest round-trip time.
Name RFC4668 Name Description
IP
Address
-
IP address and UDP port for the authentication server in
question.
State
-
Shows the state of the server. It takes one of the following
values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP communication
is not yet up and running.
Ready: The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept
access attempts.
Dead (X seconds left): Access attempts were made to
this server, but it did not reply within the configured
timeout. The server has temporarily been disabled, but
will get re-enabled when the dead-time expires. The
number of seconds left before this occurs is displayed in
parentheses. This state is only reachable when more than
one server is enabled.