User manual

User Manual
Publication date: Feb., 2013
Revision A3
208
4-2 ARP Inspection
The section describes to configure the ARP Inspection parameters of the switch. You could
use the ARP Inspection configure to manage the ARP table.
4-2.1 Configuration
This section describes how to configure ARP Inspection setting including：
Mode (Enabled and Disabled)
Port (Enabled and Disabled)
Web Interface
To configure an ARP Inspection Configuration in the web interface:
1. Select “Enabled” in the Mode of ARP Inspection Configuration.
2. Select “Enabled” of the specific port in the Mode of Port Mode
Configuration.
3. Click Save.
Figure 4-2.1: The ARP Inspection Configuration
Parameter description:
z Mode of ARP Inspection Configuration :
Enable the Global ARP Inspection or disable the Global ARP Inspection.
z Port Mode Configuration :
Specify ARP Inspection is enabled on which ports. Only when both Global Mode and Port
Mode on a given port are enabled, ARP Inspection is enabled on this given port.
z Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
Translate dynamic to static - Click to translate all dynamic entries to static
entries.