User manual

User Manual
Publication date: Feb., 2013
Revision A3
200
3-21 Trap Event Severity
The function is used to set an Alarm trap and get the Event log. The Trap Events
Configuration function is used to enable the switch to send out the trap information while pre-
defined trap events occurred.
Web Interface
To configure the Trap Event Severity Configuration in the web interface:
1. Click Configuration, Trap Event Severity Configuration
2. Scroll to select the Group name and Severity Level
3. Click the save to save the setting
4. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 3-21.1: The Trap Event Severity Configuration
Parameter description:
z Group Name :
The name identifying the severity group.
z Severity Level :
Scroll to select a severity level on each group. The following level types are supported:
<0> Emergency: System is unusable.
<1> Alert: Action must be taken immediately.
<2> Critical: Critical conditions.
<3> Error: Error conditions.