User manual

Publication date: Feb., 2013
Revision A3
195
3-18.2 Information
The section describes how to display the Single IP information what you set on the switch.
Web Interface
To show the Single IP in the web interface:
1. Click Configuration, Single IP, and then information
2. Click refresh or evoke auto-refresh to automatic update information.
Figure 3-18.2: The Single IP information
Parameter description:
z Index:
The ID of the active Slave Switch. The parameter lets you know how many slave devices
connect to the SIP group.
z Model name:
Displays the model name of the Slave Switch. The parameter lets you to know what kind
device join to this SIP group.
z MAC Address:
Displays the Ethernet MAC address of the Slave Switch. The parameter lets you to know
what device’s MAC address and join to this SIP group.
z Buttons:
Refresh –Click to refresh the page immediately.
Auto-Refresh- Check this box to enable an automatic refresh of the page at regular
intervals.
NOTE: When you click the index then you will redirect to
slave device and do the switch configuration or display/
management the device.