User manual

Publication date: Feb., 2013
Revision A3
193
3-17.2 Status
The section describes how to display the Loop Protection status what you set on the switch
and the Loop protection status.
Web Interface
To display the Loop protection parameters in the web interface:
1. Click Configuration, Loop protection, Status
2. Evoke to select enable or disable the auto-refresh.
3. Click the refresh to clear or update the record of Loop protection.
Figure 3-17.2: The Loop Protection Status.
Parameter description:
z Port:
The switch port number of the logical port.
z Action:
The currently configured port action.
z Transmit:
The currently configured port transmit mode.
z Loops:
The number of loops detected on this port.
z Status:
The current loop protection status of the port.
z Loop:
Whether a loop is currently detected on the port.
z Time of Last Loop:
The time of the last loop event detected.
z Buttons:
Refresh –Click to refresh the page immediately.
Auto-Refresh- Check this box to enable an automatic refresh of the page at regular
intervals.