User manual

Publication date: Feb., 2013
Revision A3
153
• GARP Applicant
z Timer Values :
To set the GARP join timer, leave timer and .leave all timers, units are Micro-second.
Three different timers can be configured on this page:
Join Timer: The default value for Join timer is 200ms.
Leave Timer: The range of values for Leave Time is 600-1000ms. The default value
for Leave Timer is 600ms.
Leave All Timer: The default value for Leave All Timer is 10000ms
z Application :
Currently only supported application is GVRP.
z Attribute Type :
Currently only supported Attribute Type is VLAN.
z GARP Applicant
This configuration is used to configure the Applicant state machine behavior for GARP on a
particular port locally.
• normal-participant: In this mode the Applicant state machine will operate normally in
GARP protocol exchanges.
• non-participant: In this mode the Applicant state machine will not participate in the
protocol operation.
The default configuration is normal participant.
z Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.