User manual

Publication date: Feb., 2013
Revision A3
129
3-10 VLAN
To assign a specific VLAN for management purpose. The management VLAN is used to
establish an IP connection to the switch from a workstation connected to a port in the VLAN.
This connection supports a VSM, SNMP, and Telnet session. By default, the active
management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN
by configuring System->IP->IPv4->VLAN ID. Only one management VLAN can be active at a
time.
Figure 3-10.1.1: IP Configuration for management VLAN
When you specify a new management VLAN, your HTTP connection to the old management
VLAN is lost. For this reason, you should have a connection between your management
station and a port in the new management VLAN or connect to the new management VLAN
through a multi-VLAN route.
3-10.1 VLAN Membership
The VLAN membership configuration for the selected switch can be monitored and modified
here. Up to 4094 VLANs are supported. This page allows for adding and deleting VLANs as
well as adding and deleting port members of each VLAN.
Web Interface
To configure VLAN membership configuration in the web interface:
1. Click VLAN membership Configuration.
2. Specify Management VLAN ID from 1~ 4094.
3. Click Save.
Figure 3-10.1.2: The VLAN Membership Configuration