System information

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, P. O. Box 214, 658 14 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
76
GVRP State:
This function is simply to let you enable or disable GVRP function. You can pull
down the list and click the <Downward> arrow key to choose “Enable” or
“Disable”. Then, click the <Apply> button, the system will take effect immediately.
Join Time:
Used to declare the Join Time in unit of centisecond. Valid time range: 20 –100
centisecond, Default: 20 centisecond.
Leave Time:
Used to declare the Leave Time in unit of centisecond. Valid time range: 60 –300
centisecond,
Default: 60 centisecond.
Leave All Time:
A time period for announcement that all registered device is going to be de-
registered. If someone still issues a new join, then a registration will be kept in the
switch. Valid range: 1000-5000 unit time,
Default: 1000 unit time.
Default Applicant Mode:
The mode here means the type of participant. There are two modes, normal
participant and non-participant, provided for the user’s choice.
Normal:
It is Normal Participant. In this mode, the switch participates normally in
GARP protocol exchanges. The default setting is Normal.
Non-Participant:
It is Non-Participant. In this mode, the switch does not send or reply any
GARP messages. It just listens messages and reacts for the received
GVRP BPDU.
Default Registrar Mode:
The mode here means the type of Registrar. There are three types of parameters
for registrar administrative control value, normal registrar, fixed registrar and
forbidden registrar, provided for the user’s choice.
Normal:
It is Normal Registration. The Registrar responds normally to incoming
GARP messages. The default setting is Normal.
Fixed:
It is Registration Fixed. The Registrar ignores all GARP messages, and
all members remain in the registered (IN) state.
Forbidden:
It is Registration Forbidden. The Registrar ignores all GARP messages,
and all members remain in the unregistered (EMPTY) state.
Restricted Mode:
This function is used to restrict dynamic VLAN be created when this port received
GVRP PDU. There are two modes, disable and enable, provided for the user’s
choice.
Disabled: