System information

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, P. O. Box 214, 658 14 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
2
Chapter 1
Introduction
1-1. Overview of 065-7851
065-7851, a 24-port Gigabit L2 Plus Managed Switch, is a standard switch that meets
all IEEE 802.3/u/x/z Gigabit, Fast Ethernet specifications. 16-Port 1000Mbps SFP and 8-Port
Combo Gigabit TP/SFP Fiber dual media management Ethernet switch. The switch can be
managed through RS-232 serial port via directly connection, or through Ethernet port using
CLI or Web-based management unit, associated with SNMP agent. With the SNMP agent,
the network administrator can logon the switch to monitor, configure and control each port’s
activity in a friendly way. The overall network management is enhanced and the network
efficiency is also improved to accommodate high bandwidth applications. In addition, the
switch features comprehensive and useful functions such as QoS (Quality of Service),
Spanning Tree, VLAN, Port Trunking, Bandwidth Control, Port Security, SNMP/RMON, IGMP
Snooping capability via the intelligent software. It is suitable for both metro-LAN and office
applications.
In this switch, Port 1 and Port 8 include two types of media --- TP and SFP Fiber (LC,
BiDi LC…); this port supports 10/100/1000Mbps TP or 1000Mbps SFP Fiber with auto-
detected function. 1000Mbps SFP Fiber transceiver is used for high-speed connection
expansion.
⎯ 1000Mbps LC, Multi-Mode, SFP Fiber transceiver
⎯ 1000Mbps LC, 10km, SFP Fiber transceiver
⎯
1000Mbps LC, 30km, SFP Fiber transceiver
⎯
1000Mbps LC, 50km, SFP Fiber transceiver
⎯ 1000Mbps BiDi LC, 20km, 1550nm SFP Fiber WDM transceiver
⎯ 1000Mbps BiDi LC, 20km, 1310nm SFP Fiber WDM transceiver
10/100/1000Mbps TP is a standard Ethernet port that meets all IEEE 802.3/u/x/z
Gigabit, Fast Ethernet specifications. 1000Mbps SFP Fiber transceiver is a Gigabit Ethernet
port that fully complies with all IEEE 802.3z and 1000Base-SX/LX standards.
1000Mbps Single Fiber WDM (BiDi) transceiver is designed with an optic Wavelength
Division Multiplexing (WDM) technology that transports bi-directional full duplex signal over a
single fiber simultaneously.
For upgrading firmware, please refer to the Section 3-21 or Section 4-2-2 for more
details. The switch will not stop operating while upgrading firmware and after that, the
configuration keeps unchanged.
Note:
The switch was for using indoor purpose, if it was used in outdoor environment
or connect with cable to outdoor then it must to use a lightning arrester to protect
the switch.