System information

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, P. O. Box 214, 658 14 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
58
3-3. VLAN
The switch supports Tag-based VLAN (802.1Q) and Port-based VLAN. Support 4094
active VLANs and VLAN ID 1~4094. VLAN configuration is used to partition your LAN into
small ones as your demand. Properly configuring it, you can gain not only improving security
and increasing performance but greatly reducing VLAN management.
3-3-1. VLAN Mode
Function name:
VLAN Mode Setting
Function description:
The VLAN Mode Selection function includes five modes: Port-based, Tag- based, Metro
Mode, Double-tag and Disable, you can choose one of them by pulling down list and
selecting an item. Then, click <Apply> button, the settings will take effect immediately.
Fig. 3-17
Parameter description:
VLAN Mode:
Port-based:
Port-based VLAN is defined by port. Any packet coming in or outgoing from
any one port of a port-based VLAN will be accepted. No filtering criterion
applies in port-based VLAN. The only criterion is the physical port you
connect to. For example, for a port-based VLAN named PVLAN-1 contains
port members Port 1&2&3&4. If you are on the port 1, you can communicate
with port 2&3&4. If you are on the port 5, then you cannot talk to them. Each
port-based VLAN you built up must be assigned a group name. This switch
can support up to maximal 24 port-based VLAN groups.
Tag-based: