System information

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, P. O. Box 214, 658 14 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
5
1
Parameter Description:
Port:
Display the port number. The number is 1 – 24. Both port 1-8 are optional modules.
Link:
Show that if the link on the port is active or not. If the link is connected to a
working-well device, the Link will show the link “Up”; otherwise, it will show “Down”.
This is determined by the hardware on both devices of the connection.
No default value.
Speed / Duplex Mode:
Display the speed and duplex of all port. There are three speeds 10Mbps,
100Mbps and 1000Mbps supported for TP media, and the duplex supported is half
duplex and full duplex. If the media is 1Gbps fiber, it is 1000Mbps supported only.
The status of speed/duplex mode is determined by 1) the negotiation of both local
port and link partner in “Auto Speed” mode or 2) user setting in “Force” mode. The
local port has to be preset its capability.
Default: None, depends on the result of the negotiation.
Flow Control:
Show each port’s flow control status.
There are two types of flow control in Ethernet, Backpressure for half-duplex
operation and Pause flow control (IEEE802.3x) for full-duplex operation. The
switch supports both of them.
Default: None, depends on the result of the negotiation.
Description:
network managers provide a description of device ports.
Fig. 3-14
Parameter description of Port 1 ~ Port 24: