System information

SIGNAMAX a.s.
Seat: Palackeho trida 38, 612 00 Brno, CZ l Office: Vlarska 22, P. O. Box 214, 658 14 Brno, CZ
T:[phone] l F:[phone] l www.signamax.eu
36
Daylight Saving:
Daylight saving is adopted in some countries. If set, it will adjust the time lag or in
advance in unit of hours, according to the starting date and the ending date. For
example, if you set the day light saving to be 1 hour. When the time passes over
the starting time, the system time will be increased one hour after one minute at
the time since it passed over. And when the time passes over the ending time, the
system time will be decreased one hour after one minute at the time since it
passed over.
The switch supports valid configurable day light saving time is –5 ~ +5 step one
hour. The zero for this parameter means it need not have to adjust current time,
equivalent to in-act daylight saving. You don’t have to set the starting/ending date
as well. If you set daylight saving to be non-zero, you have to set the
starting/ending date as well; otherwise, the daylight saving function will not be
activated.
Default for Daylight Saving: 0.
The following parameters are configurable for the function Daylight Saving and
described in detail.
Day Light Saving Start :
This is used to set when to start performing the day light saving time.
Mth:
Range is 1 ~ 12.
Default: 1
Day:
Range is 1 ~ 31.
Default: 1
Hour:
Range is 0 ~ 23.
Default: 0
Day Light Saving End :
This is used to set when to stop performing the daylight saving time.
Mth:
Range is 1 ~ 12.
Default: 1
Day:
Range is 1 ~ 31.
Default: 1
Hour:
Range is 0 ~ 23.
Default: 0