User`s guide

Signamax 065-7840 24-Port 10/100/1000BaseT/TX Managed Switch
46
Mode:
Set the speed and duplex of the port. In speed, if the media is 1 Gbps
fiber, it is always 1000 Mbps and the only duplex mode permitted is full. If
the media is TP, the Speed/Duplex is comprised of the combination of
speed mode, 10/100/1000 Mbps, and duplex mode, either full duplex or
half duplex. The following table summarizes the functions the media
supports.
Media type NWay Speed Duplex
1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100
1000M Fiber ON/OFF 1000M Full
In Auto-negotiation mode, there is no default value. In Forced mode,
default value depends on your settings.
Flow Control:
There are two modes to choose from in flow control, either Enable or
Disable. If flow control is set to Enable, both parties can send a PAUSE
frame to the transmitting device(s) if the receiving port is too busy to
handle. When it is set Disable, there will be no flow control in the port. It
drops the packet if the traffic is too much to handle.
Default: Enable.