User`s guide

Signamax 065-7840 24-Port 10/100/1000BaseT/TX Managed Switch
133
4. Operation of CLI
Management
4-1. CLI Management
Please refer to Chapter 2 for basic switch installation procedures. The following is a
brief description of the procedure used to make the network connection.
-- Locate the correct DB-9 null modem cable with two female DB-9 connectors. A
null modem cable is packaged with the managed switch. Please refer to
Appendix B for the null modem cable configuration.
-- Attach the DB-9 female connector to the male DB-9 serial port connector on the
managed switch.
-- Attach the other end of the DB-9 cable to an ASCII terminal emulator or the PC's
Com1 or Com2 port. For example, a PC running Microsoft Windows’
HyperTerminal utility.
-- At the “Com Port Properties” Menu, configure the parameters as below:
Baud rate 57600
Stop bits 1
Data bits 8
Parity N
Flow control none
4-1-1. Login
The command-line interface (CLI) is a text-based interface. The user can
access the CLI through either a direct serial connection to the device or a Telnet
session. The default values of the managed switch are listed below:
Username: admin
Password: admin
After logging in successfully, the prompt will be shown as “#“ if you are the
first person logged in and your authorization is administrator; otherwise it will show
“$“. Please see the following two figures. The former means you have been
authenticated as an administrator and have full access rights on the system. The
latter means you have guest access rights and are only allowed to view the system,
without permission to apply any settings to this switch.