User`s guide

Signamax 

 065-7726SPOE / 065-7726SPOE-FP 24-Port 10/100BaseT/TX
PoE Managed Switch User Manual
Publication date: February, 2010
Revision A1.0
87
Function name:
GVRP Config
Function description:
In the function of GVRP Config, it is used to configure each port’s GVRP operation mode,
in which there are seven parameters needed to be configured described below.
Parameter description:
GVRP State Setting:
This function is simply to let you enable or disable GVRP function. You can pull
down the list and click the <Downward> arrow key to choose “Enable” or “Disable”.
Then, click the <Apply> button, the system will take effect immediately.
Join Time:
Used to declare the Join Time in units of centiseconds. Valid time range: 20 –100
centisecond, Default: 20 centisecond.
Leave Time:
Used to declare the Leave Time in unit of centiseconds. Valid time range: 60 –300
centisecond, Default: 60 centisecond.
Leave All Time:
A time period for announcement that all registered device is going to be de-
registered. If someone still issues a new join, then a registration will be kept in the
switch. Valid range: 1000-5000 unit time, Default: 1000 unit time.
Default Applicant Mode:
The mode here means the type of participant. There are two modes, normal
participant and non-participant, provided for the user’s choice.
Normal:
It is Normal Participant. In this mode, the switch participates normally in
GARP protocol exchanges. The default setting is Normal.
Non-Participant:
It is Non-Participant. In this mode, the switch does not send or reply any
GARP messages. It just listens for messages and reacts for the received
GVRP BPDU.
Default Registrar Mode:
The mode here means the type of Registrar. There are three types of parameters for
registrar administrative control value, normal registrar, fixed registrar and forbidden
registrar, provided for the user’s choice.