User`s guide
Signamax
065-7726SPOE / 065-7726SPOE-FP 24-Port 10/100BaseT/TX
PoE Managed Switch User Manual
Publication date: February, 2010
Revision A1.0
29
3. Operation of
Web-based Management
This chapter instructs you how to configure and manage the 065-7726SPOE and/or 065-
7726SPOE-FP through the web user interface it supports, to access and manage the 24 10/100
Mbps TP + 2 Gigabit dual media ports with TP/SFP Fiber management Ethernet switch. With
this facility, you can easily access and monitor through any one port of the switch all the status
of the switch, including MIBs status, each port activity, Spanning tree status, port aggregation
status, multicast traffic, VLAN and priority status, even illegal access record and so on.
The default values of the managed switch are listed in the table below:
IP Address
192.168.1.1
Subnet Mask
255.255.255.0
Default Gateway
192.168.1.254
Username
admin
Password
admin
Table 3-1
After the managed switch has been finished configuration in the CLI via the switch’s
serial interface, you can browse it. For instance, type http://192.168.1.1 in the address row in a
browser, it will show the following screen (see Fig.3-1) and ask you inputting username and
password in order to login and access authentication. The default username and password are
both “admin”. To use the interface for the first time, please enter the default username and
password, and then click the <Login> button. The login process now is completed.
Just click the link of “Forget Password” in Web UI (See Fig. 3-1) or input “Ctrl+Z” in the
CLI’s login screen (See Fig. 4-1~4-2) in case the user forgets the manager’s password. Then,
the system will display a serial No. for the user. Write down this serial No. and contact your
vendor, the vendor will give you a temporary password. Use this new password as ID and
Password, and it will allow the user to login the system with manager authority temporarily.
Due to the limit of this new password, the user only can login the system one time, therefore,
please modify your password immediately after you login in the system successfully.
In this login menu, you have to input the complete username and password respectively,
the switch will not give you a shortcut to username automatically. This looks inconvenient, but
safer.