User`s guide

Signamax







065-7726SPOE / 065-7726SPOE-FP 24-Port 10/100BaseT/TX

PoE Managed Switch User Manual

Publication date: February 2010

Revision A1.0

2-1-4-1. Configuring the Management Agent of the 065-7726SPOE and/or 065-7726SPOE-

FP through the Serial RS-232 Port

To perform the configuration through RS-232 console port, the switch’s serial port must

be directly connected to a DCE device, for example, a PC, through RS-232 cable with DB-9

connector. Next, run a terminal emulator with the default setting of the switch’s serial port. With

this, you can communicate with the switch.

In the switch, RS-232 interface only supports baud rate 57.6k bps with 8 data bits, 1 stop

bit, no parity check and no flow control.

To configure the switch, please follow the procedures below:

1. Find the RS-232 DB-9 cable with female DB-9 connector bundled. Normally, it just

uses pins 2, 3 and 7. See also Appendix B for more details on Null Modem Cable

Specifications.

2. Attaches the DB-9 female cable connector to the male serial RS-232 DB-9

connector on the switch.

3. Attaches the other end of the serial RS-232 DB-9 cable to PC’s serial port, running a

terminal emulator supporting VT100/ANSI terminal with the switch’s serial port

default settings. For example, Windows98/2000/XP HyperTerminal utility.

Note: The switch’s serial port default settings are listed as follows:

Baud rate 57600

Stop bits 1

Data bits 8

Parity N

Flow control none

4. When you complete the connection, then press <Enter> key. The login prompt will

be shown on the screen. The default username and password are shown as below:

Username = admin Password = admin

Terminal or Terminal Emulator

Fig. 2-7

RS-232 cable with female

DB-9 connector at both ends

RS-232

AC Line 100

240V 50/60 Hz

232 DB

9 Connector