Installation guide

21 SIGNAMAX LLC • www.signamax.eu
1 Blue 1mm²
48V
2 Black 1mm² 0V
3
Kelly
1mm²
Protection ground
The following is the common AC power jack:
Ground wire
Live wire
Naught wire
Connect the power supply as follows:
 Step 1: Put the power supply switch to OFF. For AC switch, connect
one side of AC power supply cable to the AC power input end of the
back panel of the switch and another side to power supply jack; for
DC switch, connect the power cable to the post according to the
description of panel silk screen on the interface.
 Step 2: Put power supply switch to ON.
 Step 3: Check whether the power supply indicator of the front panel
is on. If not, repeat step 1 and 2.
 Note
If the power supply indicator is not on after repeating the above
steps, contact the agent.
Install Modules
Install POE15-8PSE Module
The steps for installing POE15-8PSE module:
Open the module package, check the modules and then begin to
install the modules.
1) Open the chassis and install the stud bolts.
2) Insert the modules into the connectors on the main board to ensure
the reliable contact (note that the pins on the circuit board of the
modules must aim at the back of the connector socket on the main
board).
3) Tighten the screws.