User`s manual

Signamax 065-1600 series Managed Media Converter
Publication date: October, 2005
Revision 1.0
227
If the Signamax 065-1600 series had been installed on remote site, please
follow the steps below to upgrade software:
Setup of the Environment:
1. Set PC’s Ethernet Port IP Address based on the configuration of central site,
e.g. 61.162.228.xx (Signamax 065-1600 series TFTP Server Default
Value=192.168.1.176)
2. Copy the file of the new version to the path specified by TFTP Server (e.g.
C:\)
3. Run TFTP Server program (TFTPD32.EXE) on PC
4. Use Cat.5 UTP Cable to connect the router and Ethernet UTP Port of PC
Upgrade Steps:
1. Run telnet on PC (Windows 2000 Operating System is recommended) as
follows:
Telnet 10.10.100.xx
Login message will be displayed on the screen, and then user can login
the management system with the following username and password:
Username: admin
Password: admin
2. Choose Software Upgrade function to ensure that whether TFTP Server
address, image filename and path are correct or not.
3. Choose <Upgrade> button to download the software. According to the
message shown by TFTP Server, user can see that if the download of the
file is completed successfully.
4. After completing the download, the file will be saved into the flash memory
only when this file is valid.
5. Do not reboot Signamax 065-1600 series or turn its power off before the
upgrade is completed.
6. Successful message will be shown after the upgrade is completed and then
choose Reboot System function.
7. Telnet again to login the management system.
8. Choose System Information function to confirm that if the version of
firmware had been upgraded to the new one.
9. Repeat 1 – 8 steps, as needed, to upgrade the next set of Signamax 065-
Cat.5 UTP Cable
UTP to Fiber
Media Converter
Cat.5 UTP Cable
Fiber Cable
RC-2201/02:
IP: 10.10.100.xx
PC:
IP: 61.162.228.xx
Router