User`s manual

ManualsBrandsSignaMax ManualsComputer equipment065-1167DINI

226

227

228

229

230

231

232

233

234

235

Signamax 065-1600 series Managed Media Converter

Publication date: October, 2005

Revision 1.0

225

Appendix D

Software Upgrade Procedures

If the Signamax 065-1600 series has not been installed yet, please follow the steps

below to upgrade software:

Setup of the Environment:

1. Set PC’s Ethernet Port IP Address as 192.168.1.176 (Signamax 065-1600

series TFTP Server Default Value=192.168.1.176)

2. Copy the file of the new version to the path specified by TFTP Server (e.g.

C:\)

3. Run TFTP Server program (TFTPD32.EXE) on PC with the following

parameter settings:

4. Run Hyper Terminal (hypertrm.exe) on PC (Windows 2000 Operating

System is recommended), and set up the parameters of COM Port as

follows:

Baud Rate : 57600

Stop bits : 1

Data bits : 8

Parity : N

Flow control : none

Upgrade Steps:

1. Use Null Modem Cable(shipped with Signamax 065-1600 series) to connect

Signamax 065-1600 series and RS-232 port of PC.

2. Use Cat.5 UTP Cable to connect Signamax 065-1600 series and Ethernet

UTP Port of PC.

3. Turn Signamax 065-1600 series’ power on.

4. The login message will be displayed on the screen of terminal emulator

after starting up the system, and then user can login the management

system with the default username and password below:

Username: admin

Password: admin

5. Choose Software Upgrade function to ensure that whether TFTP Server

address, image filename and path are correct or not.

6. Choose <Upgrade> button to download the software. According to the

message shown by TFTP Server, user can see that if the download of the

file is completed successfully.

7. After completing the download, the file will be saved into the flash memory

only when this file is valid.

8. Do not reboot Signamax 065-1600 series or turn its power off before the

upgrade is completed.

9. Successful message will be shown after the upgrade is completed and then

choose Reboot System function to re-login the management system.

10. Choose System Information function to confirm that if the version of

firmware had been upgraded to the new one.