User`s manual

Signamax 065-1600 series managed media converter
Publication date: October, 2005
Revision 1.0
182
Standard Technical Specification
Standard Network Connections
Twisted-Pair Port Interface


 Connector
Shielded/Unshielded RJ-45, 8-pin jack


 Impedance
100 Ohms nominal


 Signal Level Output (differential)
0.95 to 1.05V (100Base-TX)


 Signal Level Input
350mV minimum (100Base-TX)


 Supported Link Length
100m


 Cable Type (10Mbps segments)
(100Mbps segments)
(1000Mbps segments)
Category 3, 4 or 5 UTP(10M)
Category 5 UTP(100M)
Category 5 UTP(1000M)
Multi-mode Fiber Optic Port Interface


 Connector
SC, LC, MT-RJ or VF-45


 Wavelength
850nm


 RX Input Sensitivity
-31 dBm maximum


 Output Power
-14 dBm to -23.5 dBm (50/125µm )
-14 dBm to -20 dBm (62.5/125µm)


 Supported Link Length
up to 220m full duplex


 Cable Type
50/125, 62.5/125µm F/O
Single-mode Fiber Optic Port Interface


 Connector
SC, LC, MT-RJ, Single fiber SC


 Wavelength
1310nm SC, LC, MT-RJ
1310/1550nm Single fiber SC


 RX Input Sensitivity
-31dBm maximum


 Output Power
-8 dBm to -15 dBm (9/125µm)


 Supported Link Length
up to 50Km in full-duplex mode


 Cable Type
9/125µm F/O (recommended)
Note: Any specification is subject to change without notice.