User`s manual

Signamax 065-1600 series managed media converter
Publication date: October, 2005
Revision 1.0
158
Function name:
Alarm Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the
alarm message via either email or SMS, or both. It depends on your settings.
An email address or a mobile phone number has to be set in the console
management of alarm configuration (See Fig. 4-45~4-46). Then, user can read
the trap information from the email or the mobile phone. This function provides
6 email addresses and 6 mobile phone numbers at most. The 16 different trap
events will be sent out to SNMP Manager when trap event occurs. After ticking
trap events, you can fill in your desired email addresses and mobile phone
numbers. Then, move the cursor to <Save> and press <Enter> key to
complete the alarm configuration. It will take effect in a few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different
systems.
Parameter description:
Email:
Mail Server: the IP address of the server transferring your email.
Username: your username on the mail server.
Password: your password on the mail server.
Email Address 1 – 6: email address that would like to receive the
alarm message.
SMS:
SMS Server: the IP address of the server transferring your SMS.
Default: 203.66.172.131
Username: your username in ISP.
Password: your username in ISP.
Mobile Phone 1-6: the mobile phone number that would like to
receive the alarm message.