User`s manual

Signamax 065-1600 series Managed Media Converter
Publication date: October, 2005
Revision 1.0
9
2-2. Starting Signamax 065-1600 series up
This section will give users a quick start for:
- Battery Installation (For RC-2202 Only)
- Cable and Hardware Installation
- Management Station Installation
- Software booting and configuration
2-2-1. Battery Installation (For RC-2202 Only)


 Ways of Installing the Battery:
1. After powering off the converter, unscrew the vacant slot dummy panel at the
bottom of the converter.
2. Then, connect the connectors of the battery and the socket at the bottom of the
converter with each other. (Please note that the red cord must be linked to the
red one and the black cord also must be linked to the black one.)
3. Fasten the vacant slot dummy panel and then reboot the converter.
Note: The battery cannot be taken out when the converter is powered on. If you
would like to replace the battery, you should power the converter off in
advance and then reboot it again after completing the installation of battery.
Fig. 2-4 Battery Installation