User`s guide

Signamax Connectivity System 065-7708, 065-7728, 065-7764
www.signamax-us.com www.signamax-eu.com
NOTE:
The console port is set at the factory for the following configuration:
Baud rate: 9,600
Data width: 8 bits
Parity: none
Stop bits: 1
Flow Control: None
4. You should see some boot-up messages displayed within your
“HyperTerminal” session.
5. At the “username” field type in “guest” or let it be empty and hit “Enter”.
6. At the “password” field type in “password” and hit “Enter”. You are now
logged into the Switch’s configuration program.
NOTE:
The factory-default User name is empty. Pass word is “password”
1.3 Telnet Management
In addition to local terminal mode operation, the Switch supports remote management
through Telnet, over the Ethernet LAN network or even over internet.
If you are using Microsoft Windows, boot up the computer, go to “Start”-“Run”.
Enter ” Telnet 192.168.2.11”, Click “ ok”.
Figure 1-7 the main page