User`s guide

Signamax Connectivity System 065-7708, 065-7728, 065-7764
www.signamax-us.com www.signamax-eu.com
Thus, all packets received by and forwarded by an untagging port will have no
802.1Q VLAN information. Untagging is used to send packets from an
802.1Q-compliant network device to a non-compliant network device.
 Trunk: Ports with tagging enabled will put the VID number, priority and other
VLAN information into the header of all packets that out of those ports. If a packet
has previously been tagged, the port will not alter the packet, thus keeping the
VLAN information intact. The VLAN information in the tag can then be used by
other 802.1Q compliant devices on the network to make packet forwarding
decisions.
Port VID (PVID)
Set the port VLAN ID that will be assigned to untagged traffic on a given port. This
feature is useful for accommodating devices that you want to participate in the VLAN
but that don’t support tagging. The Switch allows each port to set one PVID, the range
is 1~255, default PVID is 1. The PVID must be the same as the VLAN ID that the port
was defined as belonging to in the VLAN group, or the untagged traffic will be
dropped.
1. First choose 802.1Q VLAN. Click “ok”
Figure 2-31
Click “OK”. Next to view the following page: Then this page display VALN
configuration information of all port
Figure 2-32
2. Choose “port2” to enter into VLAN configuration.
The default PVID is 1